BYD F3DM Owner's Manual download pdf (Page 198)

- 198 -

F3DM Owner’s Manual

y

Do not use electrical devices,

such as audio system, light

system, for a long time when the

engine is not running.

y

Before leaving the vehicle, make

sure the doors are closed and

all electric appliances (such as

lights) are turned off.

NOTICE

Do not add electrolyte by yourself

when replace a new battery for its

lacking of electrolyte.

Jump start

If the auxiliary battery is run out,

the DM system can be started by

following procedures.

All needed tools are:

1. A set of jumper cable;

2. A vehicle with 12volt auxiliary battery

or a 12volt auxiliary battery.

You are highly recommended to call

BYD authorized dealer for help if you

are not sure about the procedures.

Before jump start your vehicle:

Turn off all the electrical components,

such as climate control, audio system,

lights .est. Turn the ignition switch to

OFF, and pull the parking brake;

To avoid causing spark, make sure that

the jumper cable connects correctly.

Procedure:

1) Remove the trunk board;

2) In order to clamp the positive and

negative terminal easily, you should

put the positive and negative plastic

protective cover aside.

3).Connect the clamp of the positive

jumper cable to the battery positive (+)

terminal;

4).Connect the clamp at the other end

of the positive jumper cable to the

positive (+) terminal on the booster

battery;

5).Connect the clamp of the negative

jumper cable to the battery negative

(–) terminal;

6).Connect the clamp at the other end

of the negative jumper cable to the

negative (–) terminal on the booster

battery.

7).Turn on the ignition switch and

starting the DM system;

8).Once your vehicle is running,

disconnect the clamp of negative

cable from your vehicle, then from the

使用手册小330.indd198 2011-4-1318:36:56

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 213 214

Comments to this Manuals

No comments