BYD e6A Owner's Manual download pdf (Page 47)

BYD e6A AUTO Owner's Manual

Doors and Keys 1-29

c. Hold the support rod end to pull the rod out

of the clip and then insert the rod end into

the hole in the front left section of the

motor hood.

To close the motor hood, lift it up slightly,

remove the support rod from the hole at the

hood and put it back into the clip. Lower the

hood and release it at a height approximately

30 cm above the fender panel to let it drop

freely.

Check that the latch is secured after closing

the motor hood.

Tips

Make sure that the hood is securely

supported by the support rod after the rod is

inserted into the groove, in order to prevent

physical injuries that could be caused by the

hood falling.

Anti-theft System

To prevent the car from theft, under anti-theft

status, if any door is opened the system will

give out alarm sound.

While the alarm system gives out sound, the

turn signal lights will flash.

System Settings

a. Shut down the motor.

b. All passengers shall get off.

c. Lock all doors.

When all doors are locked, the anti-theft

indicator will remains on. The anti-theft system

will be set up automatically after

10 seconds. The anti-theft indicator will flash

after the system is set up.

d. Make sure the indicator is flashing before

you leave the car.

If anyone in the car unlocks the door, the

anti-theft system will be activated. So do not

leave anybody in the car.

Activate Anti-theft System

The system will give out alarm sound in the

following cases:

 Any door is unlocked when the

intelligent key access function is not

used.

 The power supply is turned on when the

intelligent key starting function is not

used.

Support rod

Support rod end

Clip

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 194 195

Comments to this Manuals

No comments