BYD e6A Owner's Manual Page 103

  • Download
  • Add to my manuals
  • Print
  • Page
    / 195
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 102
BYD e6A AUTO Owner's Manual
Air Conditioning System 1-85
-- Operation Gist
To cool down the vehicle after being
parked under the hot sunlight, open the
windows and drive for several minutes
to let the hot air flow out, and then
raise the windows to cool using the air
conditioner in a short time.
Confirm that the air suction grid in the
front of windshield is not blocked (such
as leaves or snow).
When it is moist, do not cool the
windshield. Otherwise, condensation
may fog on the windshield due to the
temperature difference between the
inside and outside of the vehicle.
You must keep it ventilated under the
front seat so as to make the air fully
recycled in the car.
In cold weather, you must set the
rotating speed of blower to a high
speed for one minute so as to clear the
snow or moisture in the air inlet
channel. By doing so, you can reduce
fogging on the windows.
When following other vehicles on a
dusty road or driving in windy and dusty
conditions, it is recommended to select
the internal air recirculation mode
temporarily. Thus the external air
suctions are closed to prevent external
air and dust entering the vehicle as well.
Heating
To get best effect, set the panel of air
conditioner to the following:
Automatic operation --
Press "AUTO" button
Temperature -- set to the desired
temperature
Air suction mode -- external recirculation
(ambient air)
Air conditioner -- OFF
Manual operation --
Fan speed -- set to the desired fan speed
Temperature -- set to high temperature
Air suction mode -- external recirculation
(ambient air)
Air supply mode --
Air conditioner -- OFF
To speed warm up, enable internal air
recirculation for a few minutes. To prevent
fog on the windows, enable external air
recirculation after the car has warmed up.
Press the "A/C" button down when
warming up, it may minimize the moisture
in air flow.
To warm up when performing defrost or
defog operation for windshield, you may
choose " " mode.
Page view 102
1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 194 195

Comments to this Manuals

No comments